Tubular protection light mounting bar for the Land Rover Discovery 3 and 4.

Mounts into existing holes on the A-pillar under the plastic trim. Two holes require enlarging by approx. 1mm.

Adjustable tilt angle for maximum spread.

Optimum mounting position just above the top of the windscreen.

Designed to fit Lazer Lamps (road legal solution) but has a number of pre-drilled holes to work with any light setup.

Mounted as close to the roof line as possible for reduced wind noise.

It doesn't increase the height of the vehicle above the standard or extended roof rails.
Compatible with or without the ProSpeed roof rack.

This is our Raised Air Intake compatible version of light bar mount. It has been design to be fitted alongside the Land Rover / Terrafirma Raised Air Intake. Please note, if you're sitting it with a Safari Snorkel you can use our standard version.

If you are planning to wire your Lazer LED’s in so they can be turned on and off using the vehicles hi-beam function you will also need the Lazer CAN interface.

Please contact us for details regarding wiring, switches, different light set-ups and fitting.

Our Lazer Lamp setups include either 4 Lamp Wiring Kits for the Elite Series, or 2x 2 Lamp Wiring Kits for the standard lights. Every set-up we offer is road legal using Lazer’s E11 approved driving beams. Please state which lights you’d like when ordering.

For more information about Lazer’s products please visit their website – Lazer Lamps